Enable FUSE on NAT OpenVZ

FUSE permissions can be enabled from within the management portal, select 'VPS Configuration' then within the Menu select 'Enable Fuse in Container'.

Once permissions have been updated please ensure the VPS has been Stopped and then Started from within the Management Portal to allow the configuration to be applied.
Restarting the VM from within the instance e.g. 'shutdown -r 0' will not apply the required configuration changes on the hypervisor.

You can check the support from the VPS with the following:

ls -lah /dev/fuseĀ 


If you are encountering issues please open a support ticket with our team.

  • 5 Users Found This Useful
Was this answer helpful?

Related Articles

How To: SSH into a IPv4 NAT / IPv6 based VPS

1. Find the Shared IPv4See here for finding the shared/public IPv4. 2. Check your SSH forwarding...

Find your IPv4 NAT Instance Public IPv4 Address

1. Cheat SheetYour Public IPv4 Address on a NAT based instance can be found by checking your...

Install OpenVPN on a NAT Server

In this guide we will cover how to install OpenVPN on a NAT based VPS.Now we have a new NAT VPS,...

Configure VNC Server for NAT Forwarding

VNC server typically listens on 5900+ port ranges depending on the number of your display (e.g....